The PSM-2 self-powered stage monitor containsindependent amplifier and control electronics for one12” cone driver and one 4” diaphragm horn driver in
10Complementary power MOSFET output stages class AB/H1240 Watts (620 Watts per channel)< .02 %AcousticalCopyright © 1997, Meyer Sound Laboratories,
2According to ISO/IEC Guide and EN 45014The product herewith complies with the require-ments of the Low Voltage Directive 73/23/EEC andthe EMC Directi
3ATENCIÓN: ACCESO INTERAUTORIZADO A PERSONAL TÉACHTUNG: GEHÄUSE NICHTUND REPARATUR NUR DURCHATTENTION: ENTRETIEN ETINTERNES NE SONT AUTORIU PERSONNEL
4AC PowerThe AC voltage operating ranges for the PSM-2 are85–134 V and 165–264 V, at 50 or 60 Hz. The PSM-2performs surge suppression for high voltage
5Differential InputsAudio InputThe PSM-2 presents a 10 kΩ input impedance to a three-pin XLR connector wired with the following convention:Pin 1 — 220
6Limiting and ProtectionCircuitryTruPower Limiting SystemConventional limiters assume that the resistance of aspeaker remains constant and set the lim
7The fans draw air in through ducts on the front of thecabinet, over the heatsinks, and out the rear of thecabinet. Since dust does not accumulate in
8PSM-2 and PSW-2The PSM-2 can be used with the Meyer PSW-2, PSW-4,or 650-P self-powered subwoofers. However, due to theoverlap of frequency response b
9• To reduce the risk of electric shock, disconnect theloudspeaker from the AC mains before installing audiocable. Reconnect the power cord only after
Kommentare zu diesen Handbüchern