Meyer Sound LD-2 Bedienungsanleitung

LD-1A Line DriverPower15V+-MuteCH 1Sub φ DS-2 & SubCrossoverDS-2 φMuteMuteMuteArray EQLo CutCH 2 DS-2 & SubCrossoverMuteMute Mute MuteSign

10SpecificationsArchitectureMain (Channels 1, 2)Master Gain Control -12 to +6 dBMid-Hi, DS-2, Sub Gain Controls -12 to +6 dBLow-cut Filter for Mid-Hi

2Meyer Sound Laboratories, Inc.2832 San Pablo AvenueBerkeley, California 94702Telephone: 510 - 486 - 1166FAX: 510 - 486 - 8356E-mail: info@meyersound.

3LD-1A Signal Flow Diagram... 3Introduction... 4Audio Input ...

4IntroductionThe Meyer LD-1A Line Driver combines functionspreviously accessed on the control electronics units forexternally amplified Meyer loudspea

5AC PowerAC Inlet and Voltage Select SwitchThe LD-1A uses an international standard IEC 320Mains AC inlet. This convenient rear panel receptacleaccept

6Mid-Hi OutputThe Mid-Hi output has two switch-activated, optimizedfilters. Pushing the Lo Cut switch in activates a high-pass filter (160 Hz, Q = 0.8

7Example ConfigurationsThis section demonstrates the flexibility and utility of theLD-1A with four example applications.Speaker Placement and Polarity

8PSW-2 Flown with MSL-4;650-P on the FloorIncluding subwoofers in a flown cluster provides asmooth frequency image because the low and mid-hifrequenci

9 Safety Summary !• To reduce the risk of electric shock, disconnect the LD-1Afrom the AC mains before installing audio cable. Reconnectthe po