Meyer Sound QuickFly Spezifikationen PDF herunterladen (Seite 31)

MG-MICA MULTIPURPOSE GRID AND ACCESSORIES

PN: 05.147.034.01 A

Page 31 of 44

Meyer Sound Laboratories Inc.

www.meyersound.com

T: +1 510 486.1166

F: +1 510 486.8356

MGCP-MICA CENTER POINT RIGGING BEAM

CAUTION: When the MGCP-MICA Center Point Rigging Beam is used to pick up the MG-MICA grid

use only the ratings on table 10 (page 32). Do not use the ratings for the MG-MICA grid on previous

pages which are rated for the grid’s own pick-up points.

The optional MGCP-MICA center point rigging beam can be installed on the MG-MICA multipurpose grid to allow

single pick-up points to be used for rigging a MICA array.

List of Contents: MGCP-MICA Center Point Rigging Beam Kit (40.147.050.01)

Qty Part Number Description

12 11 10 9 8

5 4

3 2 1

FRONT

40.147.050.01 MGCP-MICA Assembly

101.277 1-8 x 2.25" Hex Head Screws

113.036 2" Flat Washer

66.147.050.01 MGCP-MICA Shims

2 116.026 1.6

Lock Washer

MGCP-MICA Installation Procedure

The MGCP-MICA can easily be installed in the ﬁeld with the following steps:

1. Using an adjustable crescent wrench or similar, remove each of the two 1-8 x 2.25" hex head bolts and washers

from the beam.

2. The orientation of the MGCP-MICA is critical to the correct operation. Position the beam as shown below, so that

the “L” angles are on the bottom part of the MG-MICA grid. Make sure that the “Front” arrow on the MGCP-MICA

is pointed in the same direction as the “Front” arrow on the MG-MICA grid, so that the numbering on the beam will

be in the correct orientation. Use shims as needed to take up any space between the beam and the grid.

3. Thread each of the bolts through the holes in the beam and into the MG-MICA grid. Make sure the washers are

placed as shown in the ﬁgure below.

4. Tighten the bolts securely.

8. ACCESSORIES FOR THE MG-MICA GRID, MICA, AND 600-HP

MGCP-MICA Center

Point Rigging Beam

Weight: 26 lbs (11.8 kg)

CAUTION: Ensure

that the bolts are

ﬁrmly secure. Approximately

15 foot pounds of torque is

recommended.

Use shims as needed

Lock washer

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Meyer Sound QuickFly Spezifikationen Seite 31

Kommentare zu diesen Handbüchern